Slot Requirements For General Ethernet And Fte Node Setup; Replace Cards In Expansion Slots; Table 4-3 Slot Requirements For General Ethernet And Fte Node Configurations - Honeywell PE SC1430 Planning, Installation And Service Manual

4. Platform Servicing
4.4. Servicing Honeywell Options

Slot requirements for General Ethernet and FTE Node Setup

The following table identifies the specific slots for each of the Honeywell options for
general Ethernet and FTE node configurations.

Table 4-3 Slot Requirements for General Ethernet and FTE Node Configurations

Configuration
1 NIC, standard Ethernet
via on-board NIC
2 NICs, FTE Supervisory
via on-board NIC with
ControlNet
2 NICs, FTE Supervisory
co-joined via on-board
NIC with LCNP4M
2 NICs, FTE co-joined via
on-board NIC
3 NICs, FTE co-joined via
on-board NIC for EHG
3 NICs, Standard
Ethernet via on-board
NIC

Replace cards in expansion slots

Use the following procedure to replace the expansion cards in the PCI slots. See also
"Removing an Expansion Card" and "Installing an Expansion Card" in the Dell™
PowerEdge™ PE SC1430 Systems Installation and Troubleshooting Guide.
58 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
PCI-X PCI-X
slot 6 slot 5
Free Slot Free Slot
Dual NIC ControlNet
Dual NIC LCNP4M
Dual NIC Free Slot
Dual NIC Free Slot
Dual NIC Free Slot
Honeywell
PCI PCI-E
slot 4 slot 3
Free Slot Free Slot
Free Slot Free Slot
Free Slot Free Slot
Free Slot Free Slot
Free Slot Free Slot
Free Slot Free Slot
Release Independent
PCI-E
slot 1
Free Slot
Free Slot
Free Slot
Free Slot
Free Slot
Free Slot
12/2007