Honeywell PE SC1430 Planning, Installation And Service Manual page 60

4. Platform Servicing
4.4. Servicing Honeywell Options
Step
5
If you are replacing a card, place the expansion card firmly into the
expansion slot connector until the card is fully seated and all cards and
filler brackets are flush with the alignment bar.
If you are removing an expansion card permanently, install a metal filler
bracket over the empty expansion slot opening.
If you are installing a new expansion card, remove the metal filler bracket.
Place the new expansion card firmly into the expansion slot connector
until the card is fully seated and all cards and filler brackets are flush with
the alignment bar.
Note: Keep this bracket in case you need to remove the expansion card
later. Filler brackets must be installed over empty expansion card slots to
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
6
Close the card retention door.
60 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
Action
Honeywell
12/2007
Release Independent