Equipment Configuration; Electronics Module; Storage And Media Devices - Honeywell PE SC1430 Planning, Installation And Service Manual

Equipment configuration

The server platform is used for TPS and Experion nodes and can be mounted in cabinet
furniture or used as a tower unit.
When mounted in a cabinet, the enclosure uses the following amount of space:
Fixed mount: 4U (7.0 inch) of rack space
Slide mount 5U (8.75 inch) of rack space
This server is not intended to be mounted in the Icon Series console, Classic, or Z/EZ
console; hence, this document does not include instructions for these types of
installations.

Electronics module

The electronics assemblies for the server are based upon the Dual-Core Intel
processors. The standard DDR2 memory for this platform is 1GB, 667 MHz (2– 512 MB
DDR2 Single Ranked Fully Buffered DIMMs), optionally expandable to 2.0, 3.0, or 4.0
GB.
The peripheral electronics assemblies are based on the Peripheral Component
Interconnect (PCI), PCI Extended (PCI-X) and PCI Express (PCI-E) bus and support
USB 1.1/2.0.

Storage and media devices

The standard mass storage for this platform is one 80 GB, 7.2K RPM, SATA drive. This
platform supplies an onboard SATA mass storage option without RAID_1 controller. A
USB keyboard with touchpad and USB optical mouse are included with the platform. A
Honeywell supplied monitor will need to be ordered separately.
Standard media devices in the server are the CDRW/DVD-ROM drive and 3.5 inch
floppy drive.
All mass storage devices are connected via onboard SATA ports and the floppy drive and
EIDE CDRW/DVD ROM combo drive are connected via the floppy disk connector and
IDE connectors on the motherboard respectively.
12/2007 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
Release Independent Honeywell
1. System Planning
1.2. Description
® ®
Xeon
15