Additional References; Network Connections; Overview; Ethernet Network - Honeywell PE SC1430 Planning, Installation And Service Manual

3. Operation

3.2. Network Connections

Additional references

The following table lists the Dell publications that contain operation and servicing
information.
Table
3
Publication
Information Update
Dell™ PowerEdge™
Product Information
Guide
Dell™ PowerEdge™ PE
SC1430 Systems User's
Guide
Windows Installation
Instructions and Important
Information
3.2 Network Connections

Overview

Each server platform must be connected to an LCN network and/or an ETHERNET
network. The standard default for the on-board NIC in the BIOS is disabled. For general
Ethernet and some FTE configurations the BIOS must be enabled, refer to Section 4.5 to
verify BIOS settings.

Ethernet network

One ETHERNET 10/100/1000 embedded Base T connections are standard on the server
platform. TPS/Experion FTE systems will only use the installed PCI-X Dual NIC. If
you are using FTE, you must install the FTE cables according to the specific instructions
in the FTE Installation and Service Guide.
44 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
- Dell Publications for Operation and Servicing
1
Contains information on
Last-minute updates about technical
changes to your computer or advanced
technical-reference material for
experienced users or technicians
Warranty information
Safety information
How to remove and replace parts
Technical specifications
How to configure system settings
How to troubleshoot and solve
problems
Initialization of the Windows operating
system 2003
Honeywell
Available
Packaged with the
computer
Packaged with the
computer
www.dell.com
Product
Documentation CD
www.dell.com
Packaged with the
computer
www.dell.com
12/2007
Release Independent