Add Additional Memory - Honeywell PE SC1430 Planning, Installation And Service Manual

Step
7
Install the screw that secures the card retention door to the expansion slot
cage. (The top of the screw may be on the underside of the bracket.)
8
Connect the expansion card cable to the expansion card.
Note: Do not route card cables over or behind the cards. Cables routed
over the cards can prevent the system cover from closing properly or
cause damage to the equipment.
9
Rotate the hard-drive carrier back into the system.
10
Rotate the card retention mechanism back into its original position and
push the tab down until it clicks into place.
11
Reconnect the P3 power cable connector beside the power supply.
12
Replace the cover.
13
Replace the server in the cabinet.
If using the server as a tower unit, return it to its proper location.
14
Reconnect the power cords and cables to the back panel of the server.
15
Press the Power On/Off button on the platform to turn the power back on.
16
Restart the Operating System.

Add additional memory

Memory can be increased to a maximum of 4 GB. The memory capacity can be
increased to 2 GB by ordering memory option kit, MZ-PCEM05, which contains two 512
MB matched memory DIMMs. The memory capacity can be increased to 3 GB by
ordering memory option kit, MZ-PCEM04, which contains two 1 GB matched memory
DIMMs and to 4 GB by ordering two memory option kits, MZ-PCEM04. Memory
devices must be from the same memory supplier.
12/2007 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
Release Independent
4.4. Servicing Honeywell Options
Action
Honeywell
4. Platform Servicing
61