Honeywell PE SC1430 Planning, Installation And Service Manual page 54

4. Platform Servicing
4.2. Servicing the LCNP4M Card
Step
5
Insert the new LCNP4M card firmly into in the PCI-X slot 5 until the card is
fully seated and all cards and filler brackets are flush with the alignment
bar.
6
Close the card retention door.
7
Install the screw that secures the card retention door to the expansion slot
cage. (The top of the screw may be on the underside of the bracket.)
8
Reconnect the LCN MAU cable to the LCNP4M card.
Note: Do not route card cables over or behind the cards. Cables routed
over the cards can prevent the system cover from closing properly or
cause damage to the equipment.
9
Rotate the hard drive carrier back into the chassis.
10
Rotate the card retention mechanism back into its originally position and
push the tab down until it clicks into place.
54 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
Action
Honeywell
12/2007
Release Independent