4.5 Verifying Correct Bios Settings; Purpose; Accessing Bios; Table 4-5 Embedded Gb Nic 1 Bios Settings - Honeywell PE SC1430 Planning, Installation And Service Manual

4.5 Verifying Correct BIOS Settings

Purpose

All Honeywell systems must have the Honeywell recommended BIOS version.
Honeywell configures specific BIOS settings in the factory for each of the server
platform configurations. BIOS settings for the server are listed in Table 4-6 so that you
may verify the correct settings. The table below list specific embedded NIC BIOS
settings for general Ethernet and FTE configuration.

Table 4-5 Embedded GB NIC 1 BIOS Settings

Configuration
FTE only
FTE with EHG
No FTE, but 1 Ethernet port
No FTE, but 2 Ethernet ports
No FTE, but 3 Ethernet ports

Accessing BIOS

Use this procedure to access the BIOS and view the settings. DO NOT attempt to do this
procedure unless you are familiar with BIOS.
Step
1
Turn on the computer power. Press <F2> at startup to enter the BIOS
setup utility.
2 Check to see that the BIOS version is 1.3.0.
12/2007 PE SC1430-Based Honeywell Server PE SC1430-Based Honeywell Server
Release Independent
4.5. Verifying Correct BIOS Settings
BIOS setting
Disabled
Enabled without PXE
Enabled without PXE
Enabled without PXE
Enabled without PXE
Action
Honeywell
4. Platform Servicing
65