Scanning Problems - Dell H815DW User Manual

Scanning Problems

Problem
The scanner does not work.
The printer scans very slowly.
Document misfeeds or multiple feeds occur
in the DADF.
Vertical blanks or streaks appear on the
output when scanned using the DADF.
Vertical lines appear on the output when
scanned using the DADF.
A smear appears at the same location on the
output when scanned using the document
glass.
Images are skewed.
Action
Ensure that you place the document to be scanned facing down from the
document glass, or facing up in the DADF.
There may not be enough available memory to hold the document you want to
scan. Lower the scan resolution rate and then try scanning again.
Check that the USB or Ethernet cable is connected properly.
Ensure that the USB or Ethernet cable is not defective. Switch the cable with a
known good cable. If necessary, replace the cable.
If using the network TWAIN or Windows Image Acquisition (WIA) driver, check
that the Ethernet cable is connected properly and the IP address of the printer is
set correctly. To check the IP address, see "Verifying the IP Settings."
Check that the scanner is configured correctly. Check the application you want to
use to make certain that the scanner job is being sent to the correct port.
Ensure that the scanner sharing feature is disabled when you use Mac OS X before
you scan documents via an ICA compatible application such as Image Capture.
The printer does not support the scanner sharing feature of Mac OS X. Select a
printer which is directly connected to the computer via USB or wired /wireless
LAN and scan documents.
Graphics are scanned more slowly than text when using the
or Scan to Network Folder feature.
Communication speed becomes slow in scan mode because of the large amount of
memory required to analyze and reproduce the scanned image.
Scanning images at a high resolution takes more time than scanning at a low
resolution.
Check whether the DADF roller assembly is installed properly.
Ensure the document's paper type meets the specifications for the printer. See
"Supported Paper Types" for more information.
Check whether the document is properly loaded in the DADF.
Ensure that the document guides are adjusted properly.
Ensure that the number of document sheets do not exceed the maximum capacity
of the DADF.
Ensure that the document is not curled.
Fan the document well before loading it in the DADF.
Clean the DADF glass.
Clean the DADF glass.
Clean the document glass.
Before loading the document(s) on the DADF, straighten the edges of the stack of
the document(s).
Ensure that the document is loaded straight in the DADF or on the document
glass.
Scan to Email
525
Troubleshooting Guide