Dell H815DW User Manual page 168

*2
Certificate Details Category
Issued To
Issuer
Serial Number
Public Key Method
Size of Public Key
Valid From
Valid Until
Status
Certificate Purpose
Certificate Selection
Status
E-mail Address
Use this certificate
Delete
Export This Certificate Click to export the certificate to the other device.
Delete All Certificates Delete
*1
This item is available only when the self-signed certificate has been generated.
*2
This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the pages.
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the
printer.
Values:
IPsec Settings Protocol
IKE
Pre-Shared Key
Re-enter Pre-Shared Key
IKE SA Lifetime
IPsec SA Lifetime
DH Group
PFS
Remote peers IPv4 address Sets the IP address to connect to.
Remote peers IPv6 address Sets the IP address to connect to.
Non IPsec communication
policy
NOTE:
If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the operator panel.
168
Dell™ Printer Configuration Web Tool
Displays the device to certificate selected at the Certificate Management
page or SSL/TLS page.
Displays the device to certificate.
Displays the issuer to certificate.
Displays the serial number of the device.
Displays the public key method.
Displays the size of public key.
Displays the time the certificate is valid.
Displays the time the certificate is invalid.
Displays whether certificate is valid or not.
Displays the purpose of certificate.
Displays the type of device certificate you selected.
Displayed only when an e-mail address is specified in the certificate.
Click to apply this certificate to the device.
Click to delete this certificate.
Click to delete all the certificates.
Select the check box to enable the protocol.
"Pre-Shared Key" is displayed for IKE.
Sets a shared key. Up to 255 alphanumeric characters, periods, and
hyphens can be used.
Enters the shared key again to confirm it.
Sets the lifetime for IKE SA from 5 to 28,800 minutes.
Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
Sets the DH group.
Select the check box to enable the PFS setting.
Allows communication with a device which does not support IPsec.