Usb Settings - Dell H815DW User Manual

NFC Authentication
NOTE:
The NFC Authentication feature is available on the Dell Cloud Multifunction Printer | H815dw only.
Purpose:
To specify whether to enable the authentication using the NFC authentication card.
Values:
*
Disable
Enable
FIPS 140-2 Validation Mode
NOTE:
The FIPS 140-2 Validation Mode feature is available on the Dell Smart Multifunction Printer | S2815dn only.
Purpose:
To specify whether to use the FIPS 140-2 Level-1 approved encryption algorithms for RSA modules.
Values:
*
Disable
Enable
NOTE:
Communication using the following protocols will not be encrypted using FIPS 140-2 Level-1 approved encryption
algorithms even when FIPS 140-2 Validation Mode is enabled. Users are advised to turn them off manually when FIPS 140-2
Validation Mode is enabled:
• SNMP v3
• SMB
• PDF Direct Print
NOTE:
This feature may not be available for certain models.

USB Settings

Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE:
USB Port feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
Disable
*
Enable
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol. You can configure the PS Data Format settings. The
change becomes effective after the printer is turned off and then on again.
228
Understanding the Printer Menus
Does not permit the authentication using the NFC authentication card.
Permits the authentication using the NFC authentication card.
Allows the use of FIPS 140-2 Level-1 unapproved algorithms.
Allows the use of FIPS 140-2 Level-1 approved encryption algorithms.
Disables the USB interface.
Enables the USB interface.