Mitsubishi Electric FR-A700 Technical Manual page 349

(3) PU Stop Selection
When [Pr. 75 = 14 to 17], the motor can be stopped by
pressing of the PU in any of the PU operation,
External operation and Network operation modes.
Even if [Pr. 250 Stop selection
coasting to a stop, the motor will not coast to stop but
decelerate to stop by the PU stop function during
external operation.
When the inverter is stopped by the PU stop function
in other than PU operation mode,
on the PU. A fault signal is not provided.
When [Pr. 75 = 0 to 3], deceleration to stop by
valid only in the PU operation mode.
How to restart the motor (cancel PU stop (PS)) by
input from the PU in the External operation
mode is shown below.
(a) Operation panel (FR-DU07)
1) After completion of deceleration to a stop,
switch OFF the STF or STR signal.
2) Press to display
.............(
3) Press to return to
4) Turn ON the STF or STR signal.
Speed
Operation
panel
STF ON
(STR) OFF
Stop/restart example for external operation
(b) Parameter unit (FR-PU04/FR-PU07)
1) After completion of deceleration to a stop,
switch OFF the STF or STR signal.
2) Press .
EXT
.............(
3) Turn ON the STF or STR signal.
The motor can be restarted by making a reset using a
power supply reset or RES signal.
≠
9999] is set to select
is displayed
is
.
reset)
.
Time
Key
twice
Key
reset)
383
PARAMETER
2