NEC Electra Elite IPK II System User Manual page 48

Document Revision 4C
4. Dial .

- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
5. Dial the number you want to call.
If you hear "stutter" dial tone after dialing the number, ARS is requesting you to enter an Automatic Route

Selection Authorization Code. Refer to
To dial an outside number and let your system tell you when a Forced Account Code is required:
1. Access a trunk and dial the number you want to call.
If you hear "stutter dial tone after dialing the number, ARS is requesting you to enter an ARS Authorization

Code. Refer to
2. Wait for your call to go through.
- OR -
3. If you hear "Please enter an Account Code," (depending on system programming) and your
display shows ENTER ACCOUNT CODE.
Dial .
 
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
Dial your Account Code (3~16 digits, using 0~9 and #).

If Account Codes are hidden, each digit you dial shows
Dial .
 
- OR -
Press your Account Code key (PRG 15-07-01 or SC 751: code 50).
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected trunk.

2. Dial .

3. Enter the Account Code (1~16 digits).
You can enter any code of the proper length.

4. Dial .

2 - 24
Automatic Route Selection on page 2-83
Automatic Route Selection on page 2-83
for more information.
for more information.
on the telephone display.

Account Code – Forced/Verified/Unverified
Electra Elite IPK II