NEC Electra Elite IPK II System User Manual page 215

Electra Elite IPK II

15-02-22 Multiline Telephone Basic Data Setup – Multiple Incoming From Intercom and Trunk
When this option is set to 0, incoming calls to an extension indicate on any Hotline key for that
extension as solid (busy). When this option is set to 1, lighting is determined by the setting of
Program 22-01-01. When this program is set to 1, the Hotline key lights solid when a trunk call
rings in. If set to 0, the Hotline key does not light for incoming trunk calls, but lights solid for
intercom calls.

15-03-03 Single Line Telephone Basic Data Setup – Terminal Type
Enter 1 to allow a single line port to receive DTMF tones after the initial call setup. Enter 0 to
have the port ignore DTMF tones after the initial call setup. For Voice Mail, always enter 1 (e.g.,
receive DTMF tones).

15-06-01 Trunk Access Map for Extensions
Assign Trunk Access Maps to extensions.
Trunk Access Maps: 1~200

15-07-01 Programmable Function Keys
To have outside calls ring specific keys, assign trunks to line keys (code
also program function keys as trunk group (
Use the Call Redirect key (49) to allow a user to transfer a call to another extension or voice mail
without answering the call.
Trunks: 1~100

20-02-09 System Options for Multiline Telephones – Disconnect Supervision
Enable (1)/Disable (0)) disconnect supervision for the system trunks.

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-10-07 Class of Service Options (Answer Service) – Automatic Off-Hook Answer
Enable (1)/Disable (0) the extension user ability to use Auto-Answer to pick up Universal Answer
calls. This allows a user to pick up the handset instead of dialing a service code.

20-13-13 Class of Service Options (Supplementary Service) – Continued Dialing (DTMF) Signal on
ICM Call
Enable (1)/Disable (0) an extension user ability to use Continued Dialing, which allows DTMF
signal sending while talking on extension.

20-13-23 Class of Service Options (Supplementary Service) – Display the Reason for Transfer
Enable (1)/Disable (0) an extension ability to display the Reason for Transfer message.

21-01-15 System Options for Outgoing Calls – Outgoing Disable on Incoming Line (Toll
Restriction)
Enable (1)/Disable (0) the Outgoing Disable on Incoming Line feature.

21-01-16 System Options for Outgoing Calls – Supervise Dial Detection Timer
With the Outgoing Disable on Incoming Line feature, if dial tone is not detected after the
extension answers an incoming line, the system determines the call cannot complete and
releases the DTMF receiver (0~64800 seconds).
Central Office Calls, Answering
02) or Call Appearance (CAP) Keys (

Document Revision 4C
01 + trunk). You can

08 + bin).

2 - 191