NEC Electra Elite IPK II System User Manual page 875

Electra Elite IPK II
Programming

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-08-09 Class of Service Options (Outgoing Call Service) – Hotline/Extension Ringdown
Enable (1)/Disable (0) Hotline (Ringdown). If disabled in Class of Service, the settings in
Program 21-11 below have no effect.
(default: o)

21-01-09 System Options for Outgoing Calls – Ringdown Extension Timer (Hotline Start)
After the user lifts the handset, the extension automatically calls the ringdown destination after
this time (0~64800 seconds). A setting of 0 immediately rings the programmed extension. Any
other setting delays the ringdown the time programmed.
(default: 5)

21-11-01 Extension Ringdown (Hotline) Assignment
Program the ringdown (Hotline) source and destination (target) number, up to 24 digits (512
Hotline assignments). Remember to include the trunk access code (usually 9) in front of the
number when dialing outside numbers. When programming Speed Dial – System numbers as
the destination, the entry should be 753 + bin number (the service code for Speed Dialing and
the Speed Dial bin number).
(default: No Setting)
Operation
To place a call if your extension has ringdown programmed:
1. Lift the handset.
If you want to place a trunk call, press a line key before lifting the handset.

Depending on the setting of your ringdown timer, you may be able to dial an Intercom call before your ringdown

goes through.
If the destination has Handsfree Answerback enabled, your call voice announces. If the destination has Forced

Intercom Ringing enabled, your call rings.
To answer a call if you are another extension ringdown destination:
1. Speak toward telephone to answer incoming voice announcement.
- OR -
Lift the handset or press Speaker to answer ringing Intercom call.
Ringdown Extension, Internal/External
Document Revision 4C
2 - 851