NEC Electra Elite IPK II System User Manual page 196

Document Revision 4C
Option Available for FSK or DTMF Type from Analog Trunk
An option (Program 14-02-16) is available for the Caller ID which allows you to select the type of Caller
ID signal from an analog trunk – FSK or DTMF.
Conditions
To have pre-answer Caller ID from the voice mail, the call must be an unscreened transfer.

Caller ID is provided by the CPUII. The DSPII daughter board, which plugs onto the CPUII,

can provide additional resources for Caller ID if needed.
Caller ID Name can display up to 12 characters.

Caller ID Number can display up to 11 characters.

A Caller ID Number with more than 12 digits follows PRG 20-19-01 (first 10 or the last 10

digits).
Caller ID information can be stored in Speed Dialing or One-Touch bins.

Caller ID can be displayed for incoming calls and transferred calls.

ARS can block outgoing Caller ID information call-by-call. To do this, insert the Caller ID

block code (e.g., .67) in the ARS Dial Treatments.
Trunks with Privacy Release enabled display Caller ID until the call is answered. To view it

after the call is picked up, press the line key, which sets the call to private mode. To keep
the call on Privacy Release, press the Help + Exit keys.
An extension user can display the Caller ID information for a call in Park if Automatic

Handsfree in PRG 15-02-08 is set to 0 (Preselect).
An extension user can display the Caller ID information for multiple incoming calls without

answering the call by pressing the line key if Automatic Handsfree in Program 15-02-08 is
set to 0 (Preselect).
Caller ID information outputs on the SMDR report.

ANI/DNIS can use the Caller ID tables for routing. Refer to

Compatibility) on page 2-941
The system can send Caller ID digits to the voice mail if allowed in PRG 14-02-10.

When more than 20 characters are set in PRG 20-20 : Message Setup for Non-Caller ID

Data, either the first or last character is missing (based on the entry in PRG 20-19-01).
If Program 20-09-06 : Class of Service Options (Incoming Call Service ) : Incoming Time

Display is set to 1 (On), the first line displays the time and date.
When you shut down the system, incoming history data is cleared. But you can press

Speaker +
2 - 172
for more information.
9 to back up the history data.
# #

Electra Elite IPK II
T1 Trunking (with ANI/DNIS
Caller ID