Utility Function; Utility Execution - Mitsubishi Electric GT11 User Manual

9. UTILITY FUNCTION

Utility is a function, which carries out connection of GOT and PLC, screen display and operation method
settings, program/data control and self-check etc.
Refer to the following for the utility function list.

9.1 Utility Execution

For utility execution, utility has to be displayed by installing BootOS and Standard monitor OS in the C drive
(Flash memory).
There are following three types for the installing Standard monitor OS methods.
1) Drawing software
GT Designer2
GT Designer3
2) Drawing software
GT Designer2
GT Designer3
3) GOT CF card
GOT
Refer to the following for the installation which uses drawing software.
Refer to the following for the installation which uses GOT.
9 - 1
9.1 Utility Execution
Section 9.2 Utility Function List
GOT
Via USB interface or
RS-232 interface
BootOS or Standard monitor OS installation
CF card GOT
BootOS or Standard
OS file
monitor OS installation
write
CF card
GOT
OS file
BootOS, Standard
upload
monitor OS installation
CF card
GT Designer2 Version
GT Designer3 Version1 Screen Design Manual (Fundamentals)
Chapter 16 INSTALLATION OF CoreOS, BOOTOS AND STANDARD MONITOR OS
GOT
GOT
Install the CF
card in GOT
GOT
Install the CF
card in GOT
Basic Operation/Data Transfer Manual
• Installed directly from the drawing software
• When GOT is remote, installed easily
using the CF card
• Install OS from GOT to GOT using CF card