Operation Of Keyword Input - Mitsubishi Electric GT11 User Manual

14.3.5 Operation of keyword input

If a keyword is registered in the ACPU when the connected ACPU or the ACPU PLC No.
No. corresponding to the operation is changed, the GOT requests for input of the registered keyword.
Input the keyword registered in the ACPU and press the
If a keyword is not registered in the ACPU, this operation is not required.
Procedure for inputting the keyword for the MELSEC-A list editor
<Display>
* NOW READING PLC
PLESE WAIT A MOMENT
MOTION CONTOROLLER
NOT SUPPORTED
KEYWORD= [ ]
When the keyword
(040411) is input
KEYWORD= [******]
When the input keyword
is correct
KEYWORD= [ OK ]
*** MODE SELECTION ***
(READ)(INS)(PARAM)
PRESS MODE KEY
KEYWORD= [ NG ]
*1 When the input keyword does not match with the registered keyword, only the following operations in subsection
14.3.27 can be allowed.
<Key operation>
0 4 0 4 1 1 GO
When the input keyword
is not correct *1
Other modes
Error step reading
Buffer memory overall monitor
Time monitor
PLC No. setting
Main/sub switching
key.
GO
<Description of operation>
Start the list editor function.
(* shows communication status
with the PLC CPU.)
Input of the keyword is requested.
Input the keyword registered in
the connected
ACPU and press the GO key.
The GOT checks the input keyword
and displays the result.
The check result display time
is about 2 seconds.
To Mode Selection
Subsection 14.3.9
Selection and operation
of modes
14.3 MELSEC-A List Editor
14.3.5 Operation of keyword input
Input the keyword to 6 letters
maximum with the device
No./constant setting key.
("0" to "9", "A" to "F")
14 - 53
9
10
11
12
13
14
15
16