Table of Contents
Advertisement
Device entry screen when the entry monitor,
batch monitor or TC monitor is selected
5)
Set 1) to 8) as shown in the table below, and then touch the
For the operation of key windows, see the following:
No.
Item
1)
Network No.
2)
Station No.
3
CPU No.
3)*
4)
Data range
5)
Device name
1
Device number
6)*
1
I/O number
7)*
Initial device
1
8)*
number
*1
For devices that can be set, see the following:
*2
Indicates CC-Link connection (via G4).
*3
When the station No. is set to the host station (FF), set the network No. to 0.
14 - 16
14.2 System Monitor
14.2.5 Entering monitor devices (specifying monitor stations and devices)
1)
2)
3)
6)
4)
Subsection 14.2.6 Key window setting columns and operation procedure
Bus connection
0 to 4: This item must be set only when the system is connected to multiple QCPUs. It is not
necessary when the system is connected to another CPU.
1: Indicates that the device value is a 32-bit (two-word) module.
0: Indicates that the device value is a 16-bit (one-word) module.
Set the name and number of the device to be monitored.
When the initial I/O signal of module is displayed with three digits, specify the first two digits.
Set the initial device number of the buffer memory in decimal.
GT Designer 2 Version
GT Designer 3 Version1 Screen Design Manual(Fundamentals)
Displaying the data range
The Entry Monitor, Batch Monitor, TC Monitor, and BM Monitor screens display
the data range as shown below.
• DW
• Nothing displayed : 16-bit (one-word) module
(Continued to next page)
(From previous page)
Device entry screen when the
BM monitor is selected
7)
Enter
Description of setting
Direct CPU
Computer link
connection
connection
0
FF
Screen Design Manual
: 32-bit (two-word) module
8)
key.
CC-Link connection
G4
FF: When the host station is
selected
0: When the master station
is selected
1 to 64: When a local station
is selected
2
*
Advertisement
Table of Contents
Troubleshooting
