Specifications - Mitsubishi Electric GT11 User Manual

14.3.1 Specifications

System configuration
1
This subsection describes the PLC CPU series names and the connection forms between the GOT and
the PLC for which the MELSEC-A list editor is available.
For further information about communication units and cables for each connection form, see the
following:
Targeted PLC
2
PLC
*1*2
ACPU/QCPU (A mode)
*1 Motion controller CPUs cannot be connected. The message "MOTION CONTROLLER NOT SUPPORTED" will be
displayed when the MELSEC-A list editor function is activated.
*2 When the PLC is A2USH-S1, it operates within the range of A3U; when the PLC is the A2SH-S1, A2SH, A1SH, or
A1SJH, it operates within the range of A3N.
Connection forms
3
When the GOT is connected to an ACPU/QCPU (A mode)
Function name
Bus connection
MELSEC-A list editor
*1 When the PLC is the A2SH-S1/A2SH/A1SH/A1SJH, use a CPU of version E or a later version.
Programs cannot be written to CPUs of version D or an earlier version.
*2 When the PLC is A3N, A2N-S1, A2N, or A1N, it can not be used.
*3 When the PLC is QCPU (A mode), it cannot be used.
*4 Indicates CC-Link connection (via G4).
14 - 50
14.3 MELSEC-A List Editor
14.3.1 Specifications
GOT1000 Series Connection Manual
Direct CPU
*1*3
connection
Connection form between GOT and PLC
Computer link
connection
( : Available, : Unavailable)
CC-Link
GOT multidrop
*1*2
connection
connection
*4
G4