Table of Contents
Advertisement
FusionCol8000-E400 Modular Indirect Evaporative
Cooling System
User Manual
2.
Step 7 Secure the new compressor to the bracket again using a solid wrench.
● During welding, use a silver copper welding rod containing 5% silver. Check
that the welding joints are in good condition, without poor welding.
● To avoid burning the internal components, other pipes, thermal insulation
foam, power cables, and labels, take protective measures, such as spreading
wet cloth, around the welding joints.
● Do not use face-down bonding when welding.
● After the installation, check that the input power cables of the compressor are
in the same phase sequence as the wiring terminals.
Step 8 Weld the suction and discharge welding joints to the compressor using a welding
torch.
Step 9 Install the electric heating belt and reinstall the cover after connecting the
compressor cables.
Step 10 Remove the filter dryer and install a new one.
Issue 04 (2022-06-30)
NO TICE
After removing the compressor, block the suction and discharge vents
immediately to ensure the system cleanness and prevent water from entering.
Remove the four nut washers and spring washers that secure the compressor
and bracket using a 13# socket wrench (or solid wrench), and remove the
compressor.
Figure 9-12 Removing a compressor bracket
NO TICE
Copyright © Huawei Technologies Co., Ltd.
9 Parts Replacement
134
Advertisement
Table of Contents
