Canon FINISHER - D1 Service Manual page 99

2) Check the gap between the machine and
the copier. If the gap is still large, turn the
adjusting foot further. If done in excess, on
the other hand, turn the adjusting foot
back. Perform this for both front and rear
feet.
3) When the gap is appropriate, tighten the
fixing nuts (front, rear).
4) Mount the foot covers (front, rear).
5) Attach the spanner.
E.3 Correcting Tilt B
1) Loosen the fixing nut by turning it in the
direction of arrow C. Turn the adjusting
foot of the caster in the direction of arrow
E. Perform this on both front and rear feet.
2) Check the gap between the machine and
the copier. If the gap is still narrow, turn the
adjusting foot further. If done in excess, on
the other hand, turn the adjusting foot
back. Perform this on both front and rear
feet.
3) When the gap is appropriate, tighten the
fixing nuts (front, rear).
4) Mount the foot covers (front, rear).
5) Attach the spanner.
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
C
Fixing nut
Figure 3-123
E
Adjusting foot
3-11