Processing Tray Unit - Canon FINISHER - D1 Service Manual

II . PROCESSING TRAY
UNIT
A. Removing the Processing
Tray Unit
1) Remove tray A.
2) Remove the stacking wall (upper).
3) Remove the screw, and remove the tray B
stopper.
4) Move up tray B as far as it goes by hand.
(See the descriptions on the upward move-
ment of tray B.)
5) Remove the four screws, and detach the
stacking wall (lower).
6) Disconnect the screw [2], and detach the
connector cover [1].
7) Disconnect the seven connectors [3], and
free the harness [4] from the cord clamp.
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[2]
Figure 3-201
[4]
Figure 3-202
[1]
[3]
3-13