Job Offset - Canon FINISHER - D1 Service Manual

CHAPTER 2 OPERATIONS
C.

Job Offset

1. Outline
In job offset mode, stacks of sheets are moved to the front or rear for sorting purposes.
The stacks are moved to the front or rear by the front jogging plate and rear jogging plate.
Sheets moving past the stack delivery roller are moved by the paddle in the direction of the stopper.
The swing guide is in up position while pulling in a sheet or while the stacking plate is in operation;
it is in down position while the stack is being delivered.
When the power is turned on, the finisher controller PCB drives the front jogging plate motor
(M4) and the rear jogging plate motor (M5) to return the two jogging plates to the home position.
Sensor
Front jogging plate
home position sensor
Rear jogging plate
home position sensor
Swing guide closed
sensor
Swing guide open
sensor
Paddle home
position sensor
Table 2-203
2-22
COPYRIGHT © 1999 CANON INC.
Notation Connector
PI7 J104B-3
PI9 J104B-9
PI15 J108B-3
PI16 J108B-6
PI14 J108A-8
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Function
Drives the front Front jogging plate
jogging plate motor
Drives the rear Rear jogging plate
jogging plate motor
Swing guide drive Swing motor
Drives the paddle Paddle motor
(feeds paper)
Table 2-204
Motor Notation
M4
M5
M8
M9