Canon FINISHER - D1 Service Manual page 121

7) Remove the upper rear cover and the rear
cover.
8) Remove the E-ring [9] from the rear end of
the buffer roller shaft; then, remove the
bearing [10].
9) Disconnect the connector [12], and re-
move the screws; then, remove the buffer
motor [11].
10) Remove the E-ring [13] of the buffer roller
shaft, and remove the gear [14].
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[9]
[10]
Figure 3-606
[11]
Figure 3-607
[13]
[14]
Figure 3-608
[12]
3-33