Tray B Unit - Canon FINISHER - D1 Service Manual

III . TRAY B UNIT
A. Removing the Tray B Unit
1) Remove tray A.
2) Open the front cover and the upper cover;
then, remove the screw, and detach the
stopper.
3) Remove the screw, and detach the support
cover.
4) Remove the upper rear cover and the rear
cover.
5) Disconnect the connector [1], and the
grounding wire [2]; then, free the harness
from the cord clamp [3].
6) Remove the two screws, and detach the
harness holder [4].
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
Figure 3-301
Figure 3-302
[1]
[3]
[2]
[4]
3-21