Table of Contents
Advertisement
10) Slide the stapler holder [9] until the stapler
paper stopper [8] comes into contact with
the stack of sheets; then, tighten the screw.
4.
After Positioning the Stapler
After adjusting the position of the stapler,
make sure of the following:
• The knurled belt roll and the stapler edge
will not interfere when the knurled belt
releasing solenoid is fully pulled while the
stapler is in 2-point stapling position.
If Interference Occurs
1. Check the position of the knurled belt re-
leasing solenoid.
2. Move the stapler in the direction of arrow
A until interference stops.
COPYRIGHT © 1999 CANON INC.
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[9]
Figure 3-717
Knurled belt roll
Stapler edge
A
Figure 3-718
[8]
3-41
Advertisement
Table of Contents
Troubleshooting
