Canon FINISHER - D1 Service Manual page 87

MECHANICAL SYSTEM
The mechanical characteristics of the finisher are discussed in the following pages;
go through the instructions given when disassembling/assembling the finisher's
parts while keeping the following in mind:
1. Disconnect the power plug before disassembly/assembly work.
!
2. Assemble the parts by reversing the steps used to disassemble them, unless
otherwise noted.
3. Identify the screws by type (length, diameter) and location.
4. Do not leave out the washer that comes with the screw used for the grounding
wire and the varistor to ensure electrical continuity.
5. Do not operate the machine with any of its parts removed, unless otherwise
mentioned.
I. EXTERNALS AND CONTROLS
.................................................... 3-1
II. PROCESSING TRAY UNIT ...... 3-13
III. TRAY B UNIT ............................ 3-21
IV. KNURLED BELT RELEASING UNIT
.................................................. 3-28
COPYRIGHT © 1999 CANON INC.
CHAPTER 3
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
V. KNURLED BELT ....................... 3-30
VI. BUFFER ROLLER UNIT ........... 3-31
VII. STAPLER UNIT ........................ 3-35
VIII. PCBs ......................................... 3-42