Canon FINISHER - D1 Service Manual page 127

3) While holding the swing guide, insert a
stack of sheets [3], and butt it against the
rear edge stopper [4].
4) Slide the stapler holder [6] until the stapler
paper stopper [5] comes into contact with
the stack of sheets; then, loosen the screws.
3. Positioning by Stapling
If you are not sure about the index because
of, for instance, the replacement of the stapler
holder and, in addition, the stapler paper stop-
per has moved, perform the following:
1) Release the machine from the copier.
2) Fix the stapler holder to the mount tempo-
rarily. (At this time, try to fit the screw
somewhat on the rear side.)
3) Move the stapler [1] to the center of the
rail.
4) Loosen the screw of the stapler paper stop-
per (left, right).
5) While holding the swing guide, insert a
stack of sheets [2], and butt it against the
rear end stopper [3].
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
Figure 3-711
[6]
Figure 3-712
[1]
Figure 3-713
[4] [3]
[5]
[3] [2]
3-39