Table of Contents
Advertisement
I . ADJUSTMENT
A.
Electrical System
1.
Adjusting the Alignment Width
Perform the following if you have re-
placed the EEPROM (IC102) of the finisher
controller PCB, front jogging plate motor
(M4), or rear jogging plate motor (M5):
1) Set SW103 on the finisher controller PCB
as follows:
AB Configuration
ON
1
2
3
Inch Configuration
ON
1
2
3
Figure 5-101
2) Press SW104 on the finisher controller
PCB.
• The swing guide of the machine will open
and, at the same time, the front jogging
plate and the rear jogging plate move to
the home position. Thereafter, the rear
jogging plate moves to the rear alignment
position, while the front jogging plate
moves to a point which is 'A4 width or
LTR width + α'. LED 101 on the finisher
controller PCB will indicate the initial
offset value '-4'.
3) Hold a stack of A4 or LTR sheets, and in-
sert it into the processing tray (until the
front edge of the stack butts against the
rear jogging plate).
4) Butt the rear edge of the stack against the
rear jogging plate.
COPYRIGHT © 1999 CANON INC.
4
5
6
7
8
4
5
6
7
8
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 TROUBLESHOOTING
5) Press SW105. A single press moves the
front jogging plate toward the rear by
about 0.35 mm. A single press, further, in-
crements the indication of the offset value
by LED1 on the finisher controller PCB
up to '+4'.
Press the switch as many times as neces-
sary until there is no gap between the front
edge of the stack and the front jogging
plate.
• You cannot enter a value higher than '+4'.
6) Press SW104 on the finisher controller
PCB.
• This will store the new value, and the front
jogging plate and the rear jogging plate
will return to the home position.
• If you have pressed SW104 too many
times and the front jogging plate has
moved too far, press SW106 on the fin-
isher controller PCB. In response, the
front jogging plate will move to the home
position once, and then move back to the
adjustment start position. Go back to step
5), and repeat the steps.
7) Turn off the power.
8) Shift all bits of SW103 on the finisher
controller PCB to OFF.
9) Turn on the power.
• The swing guide will move down.
2.
Adjusting the Stapling Position
(front 1-point stapling)
If you have replaced the EEPROM
(IC102) on the finisher controller PCB or the
stapler, perform the following:
1) Set SW103 on the finisher controller PCB
as follows:
AB Configuration
ON
1
2
3
Inch Configuration
ON
1
2
3
Figure 5-102
4
5
6
7
8
4
5
6
7
8
5-1
Advertisement
Table of Contents
Troubleshooting
