Canon FINISHER - D1 Service Manual page 86

CHAPTER 2 OPERATIONS
Jam Sensor
Inlet delay PI2
Inlet PI2
stationary
Buffer path Buffer path paper
delay sensor
Buffer path Buffer path paper
stationary sensor
Non-sort PI6
delay
Non-sort PI6
stationary
Lower path Lower path paper
delay sensor (S3)
Lower path Lower path paper
stationary sensor (S3)
PI1
Door open
Power-on PI2, PI6, buffer
path paper sensor
(S2), lower path
lower sensor (S3)
Staple PI19
2-60
COPYRIGHT © 1999 CANON INC.
The input path sensor did not turn on a specific time after the
copier had generated the delivery signal.
The paper did not move past the sensor when it was fed a
specific length (paper length + 100 mm) after the sensor had
detected it.
The buffer path paper sensor did not detect the paper when it
was fed a specific length (438 + 150 mm) after the inlet path
sensor had turned on.
The paper did not move past the sensor when it was fed a
specific length (paper length + 100 mm) after the sensor had
detected it.
The non-sort delivery sensor did not detect the paper when it
was fed a specific length (348 + 150 mm) after the inlet path
sensor had turned on.
The paper did not move past the sensor when it was fed a
specific length (paper length + 100 mm) after the inlet path
sensor had turned on.
The lower path paper sensor did not detect the paper when it
was fed a specific length (540 + 150 mm) after the inlet path
sensor had turned on.
The paper did not move past the sensor when it was fed a
specific length (paper length + 100 mm) after the sensor had
detected it.
The front door was opened during feeding operation.
Either of the sensors indicated on the left detected paper when
power was turned.
When the stapler motor was rotated clockwise, the sensor did
not turn on 0.5 sec after it had turned off; in addition, the
sensor turned on within 0.5 sec when the staple motor was
rotated counterclockwise. (If the sensor remains off 0.5 sec
after the motor was rotated counterclockwise, an error will be
identified.)
Table 2-901
CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Description Code
16
26
17
27
18
28
19
29
08
07
06