Tools; Components; Alternator; On/Off Switch - Toro 30284 Service Manual

Tools

• Volt Ohm meter
• Flat and Phillips screwdrivers
• Box and open end wrenches - various sizes
Additional information can be found in the LCE Electrical
Troubleshooting DVD #492-9171, available through your
Toro parts supplier.
Caution
Before performing any tests with a continuity
light or ohmmeter, disconnect the component
from the wire harness. This ensures you are test-
ing the component rather than another circuit.
Interlock modules MUST be removed from the
circuit before performing any tests with an ohm-
meter or continuity light. Battery voltage can
damage these modules if applied to the wrong
terminals.

Components

Alternator

The alternator system varies with the engine model. See
the engine manufacturer service information for proper
testing procedures.
Floating Deck Mid-Size Service Manual
ELECTRICAL

On/Off Switch

The on/off switch is mainly used to control the spark on
recoil start models. In the off position there is contact
between the terminals. When turned 1/4 turn clockwise
to the on position the contacts open (Fig. 1393).
Fig 1393

Bail Switch

The bail switch is a normally open switch. The contacts
close when the plunger is depressed (Fig. 1394).
Fig 1394
29-5560x1
9
82-2190x1a
9-1