Handle Assembly Removal (T-2) - Toro 30284 Service Manual

LINKAGE
26. Plug the two harness wires into the harness con-
nector as shown (Fig. 0601):
4
27. Plug the harness connector into the OPC switch
(Fig. 0602).
4-80
Fig 0601 PICT-1742
Fig 0602 PICT-1744
28. Connect the negative battery terminal to the battery.
29. Check the Adjustment of the Control Bar. Refer to
"Control Bar Adjustment" on page 4-132.

Handle Assembly Removal (T-2)

Fig 0603
1. Turn the engine off and remove the key from the
ignition.
2. Disconnect the negative battery terminal from the
battery.
Floating Deck Mid-Size Service Manual
fi g. 3 G006080