Wheel Motor Replacement; Wheel Motor Removal - Toro 30284 Service Manual

15. Install the idler spring onto the tab on the chassis
(Fig. 1002).
Fig 1002
16. Check the oil level in the hydraulic reservoir and fi ll
as necessary.
17. Remove air from the hydraulic system. Refer to
"Bleeding the Hydraulic System" on page 6-32.
Floating Deck Mid-Size Service Manual
HYDROSTATIC DRIVE SYSTEM

Wheel Motor Replacement

Note: Cleanliness is a key factor in a successful
PICT-0402
Note: The following procedures can be followed for

Wheel Motor Removal

1. Apply the parking brake.
2. Loosen the 4 lug nuts (Fig. 1003).
repair of any hydraulic system. Thoroughly
clean all exposed surfaces prior to any type
of maintenance. Cleaning all parts by using
a solvent wash and air drying is usually
adequate. As with any precision equipment,
all parts must be kept free of foreign material
and chemicals. Protect all exposed sealing
areas and open cavities from damage and
foreign material.
Upon removal, all seals, O-rings, and gaskets
should be replaced. During installation, lightly
lubricate all seals, O-rings, and gaskets with
clean petroleum jelly prior to assembly.
For wheel motor service information, refer
to Parker/Ross Wheel Motor Service Manual
(492-4753).
both the right and the left wheel motor.
Fig 1003
6
PICT-0442a
6-19