Ssd Module - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Step 4 Remove the server. For details, see
Step 5 Remove the chassis cover. For details, see
Step 6 Remove the riser card tray where the RAID controller card is to be installed. For details, see
3.12 Removing a Riser Card
Step 7 Take a spare Avago SAS3004iMR RAID controller card out of the ESD bag.
Step 8 Install the Avago SAS3004iMR RAID controller card. For details, see
Riser
Step 9 Install the riser card tray. For details, see
Step 10 Install the M.2 SSD modules on the Avago SAS3004iMR RAID controller card. For details,
see
Step 11 Install the chassis cover. For details, see
Step 12 Install the server. For details, see
Step 13 Connect the power cables. For details, see
Step 14 Power on the server. For details, see
Step 15 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End
5.10 M.2 SSD Module
To install an M.2 SSD module, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Take an M.2 SSD module out of its ESD bag.
Step 3 Open the handle that secures the M.2 SSD module, push the module into a slot in the Avago
SAS3004iMR RAID controller card, and close the handle. See
Issue 04 (2018-09-04)
Card.
5.10 M.2 SSD Module.
Huawei Rack Server iBMC User
NOTE
M.2 SSD modules support hot swap. You do not need to power off the server when installing an M.2

SSD module.

Copyright © Huawei Technologies Co., Ltd.
3.2 Powering Off the
3.7 Removing Cables from a
3.3 Removing the Server and Guide
3.4 Removing the Chassis
Tray.
3.13 Installing a Riser Card
3.5 Installing the Chassis
4.4 Installing the Server on Guide
5.4 PSU.
3.1 Powering On the
Guide.
12 Preventing Electrostatic
5 Optional Part Installation
Server.
PSU.
Rails.
Cover.
5.5 PCIe Card on a
Tray.
Cover.
Rails.
Server.
Discharge.
Figure 5-35.
142