Screw-In Raid Controller Card - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Step 9 Install the chassis cover. For details, see
Step 10 Install the server. For details, see
Step 11 Connect the power cables. For details, see
Step 12 Power on the server. For details, see
----End

5.8 Screw-in RAID Controller Card

To install the screw-in RAID controller card on the mainboard, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Step 4 Remove the server. For details, see
Step 5 Remove the chassis cover. For details, see
Step 6 If I/O module 2 is configured with a full-height full-length riser card tray, remove the riser
card tray. For details, see
Step 7 Take a spare RAID controller card out of its ESD bag.
Step 8 If a supercapacitor is required, install it. For details, see
Step 9 Determine the position for installing the RAID controller card on the mainboard. See
5-33.
Figure 5-33 Position of the RAID controller card
Issue 04 (2018-09-04)
4.4 Installing the Server on Guide
3.1 Powering On the
3.2 Powering Off the
3.3 Removing the Server and Guide
3.12 Removing a Riser Card
Copyright © Huawei Technologies Co., Ltd.
3.5 Installing the Chassis
5.4 PSU.
Server.
12 Preventing Electrostatic
Server.
3.7 Removing Cables from a
3.4 Removing the Chassis
Tray.
5.11 Supercapacitor.
5 Optional Part Installation
Cover.
Rails.
Discharge.
PSU.
Rails.
Cover.
Figure
140