Avago Sas3004Imr Raid Controller Card - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Step 10 Align the connector on the RAID controller card with the port on the mainboard, and insert
the RAID controller card slowly into the mainboard. See (1) in
Figure 5-34 Installing the RAID controller card
Step 11 Tighten the screws on the RAID controller card. See (2) in
Step 12 Connect cables to the RAID controller card. For details, see
Step 13 Install the chassis cover. For details, see
Step 14 Install the server. For details, see
Step 15 Connect the power cables. For details, see
Step 16 Power on the server. For details, see
Step 17 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
Step 18 To configure the RAID controller card in EFI/UEFI mode, upgrade the firmware. For the LSI
SAS3008 RAID controller card, upgrade the firmware to V109 or later; for the LSI SAS3108
RAID controller card, upgrade the firmware to V110 or later. For details, see the
Server Firmware Upgrade
----End

5.9 Avago SAS3004iMR RAID Controller Card

To install the Avago SAS3004iMR RAID controller card, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Issue 04 (2018-09-04)
Huawei Rack Server iBMC User
Copyright © Huawei Technologies Co., Ltd.
3.5 Installing the Chassis
4.4 Installing the Server on Guide
5.4 PSU.
3.1 Powering On the
Guide.
Guide.
12 Preventing Electrostatic
5 Optional Part Installation
Figure 5-34.
Figure 5-34.
7 Internal Cabling.
Cover.
Rails.
Server.
Huawei
Discharge.
141