Pcie Card On A Riser Card - Huawei 2288H V5 User Manual

2288H V5 Server
User Guide
Connect the power cables to the wiring terminal on the PSU until the power cables are
latched. See (1) in
l
l
Loosen and remove the screw from the ground hole, connect one end (OT terminal) of the
ground cable to the removed screw, install the screw on the ground hole, and tighten the
screw. See (2) in
Figure 5-23 Connecting cables to a DC PSU
Step 6 Log in to the iBMC WebUI, and check whether the new component is normal. For details, see
the
----End

5.5 PCIe Card on a Riser Card

To install a PCIe card on a riser card, perform the following steps:
Step 1 Wear an ESD wrist strap. For details, see
Step 2 Power off the server. For details, see
Step 3 Remove the power cables. For details, see
Step 4 Remove the server. For details, see
Step 5 Remove the chassis cover. For details, see
Step 6 Remove the riser card tray where the PCIe card is to be installed. For details, see
Removing a Riser Card
Step 7 Take a spare PCIe card out of its ESD bag.
Step 8 Remove the PCIe card filler panel from the riser card. See (1) and (2) in
Issue 04 (2018-09-04)
Figure 5-23.
Connect the OT terminal on the negative power cable (black) to the NEG(-) wiring
terminal on the PSU.
Connect the OT terminal on the positive power cable (blue) to the RTN(+) wiring
terminal on the PSU.
Figure 5-23.
Huawei Rack Server iBMC User
Tray.
Copyright © Huawei Technologies Co., Ltd.
Guide.
12 Preventing Electrostatic
3.2 Powering Off the
3.7 Removing Cables from a
3.3 Removing the Server and Guide
3.4 Removing the Chassis
5 Optional Part Installation
Discharge.
Server.
PSU.
Rails.
Cover.
3.12
Figure 5-24.
132