Battery Shallow Discharge Test - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Procedure
Step 1 Press the networking switch on the iBOX for 2 seconds. The ALM indicator blinks
red once, and the RF_Z indicator turns from steady green to blinking green at
super short intervals, which indicates that the iBOX is being networked.
Step 2 Press the iBAT networking switch for 2 seconds. When the RUN/ALM indicator
turns from steady red to blinking green at super short intervals (iBattery 2.0) or
short intervals (iBattery 3.0), and finally to blinking green at long intervals, the
iBAT connects to the iBOX network.
Step 3 Perform networking operations on the next iBAT only after networking for the
previous iBAT is successful. Repeat
Step 4 Press the iBOX networking switch for 2 seconds. When the RF_Z indicator on the
iBOX turns from blinking green at super short intervals to blinking green at long
intervals, the networking is complete.
Step 5 (Optional) If multiple iBOXs are cascaded, repeat
networking for remaining iBOXs and iBATs.
----End

6.9.3 Battery Shallow Discharge Test

To facilitate O&M, you can configure a battery shallow discharge test on the
Linkage Control tab page.
Prerequisites
Only the UPS2000-G-(6 kVA–10 kVA) and UPS2000-G-3 kVA (dual-live wire)
support a battery shallow discharge test on the ECC800-Pro.
You need to manually configure the battery shallow discharge test based on
requirements.
The system type is FusionModule500.
Issue 02 (2020-09-07)
– Blinking at short intervals: The indicator is on for 0.125 seconds and then
off for 0.125 seconds alternately.
NO TE
● It is recommended that iBATs be networked from the positive battery string terminal
according to the battery cable connection sequence.
● Batteries are numbered depending on the sequence of connecting iBATs to the iBOXs.
NO TE
After the networking is complete, if the ALM indicator on the iBOX is steady on, the
number of devices online is smaller than the value of iBAT Number. Check that iBAT
Number is set to a correct value and that the iBAT is successfully networked.
Copyright © Huawei Technologies Co., Ltd.
Step 2 to add other iBATs to the iBOX network.
Step 1
6 Feature Description
to Step 4 to perform
213