Huawei ECC800-Pro User Manual page 294

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
1.
2.
Step 2 Add a PMAC615.
1.
2.
3.
Issue 02 (2020-09-07)
After the PMAC615 is started, press
configuration screen is displayed. Press
indicating the communications address setting screen.
Press and a blinking cursor is displayed. Press
communications address based on site requirements. Then press
confirm the address setting.
Figure 8-16 PMAC615 communications address
Log in to the ECC800-Pro WebUI as an administrator.
Add a PMAC615.
Table 8-17 Adding a PMAC615
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the PMAC615 connects to the ECC800-
Pro properly.
– If the PMAC615 connects to the ECC800-Pro successfully, click Confirm.
The connected devices are displayed in the Number of connected
devices list.
Copyright © Huawei Technologies Co., Ltd.
on the displayed screen and the
until the ID prompt is displayed,
Setting
Select Electricity Meter from the drop-
down list box.
Select PMAC615 from the drop-down list
box.
Select ECC800 from the drop-down list
box.
Select COM3 from the drop-down list box.
NOTE
The setting example indicates that the
PMAC615 is connected to the COM3 port on
the ECC800-Pro. If the PMAC615 is connected to
another port, enter the number of the
connected port.
In this example, Device Address is set to 8.
During actual configuration, set the device
address for the PMAC615 based on the
actual situation.
8 FAQ
to modify the
to
283