Huawei ECC800-Pro User Manual page 303

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Step 2 Add a NetCol5000-C030.
1.
2.
3.
Step 3 Set the running parameters and control parameters for the NetCol5000-C030 on
the WebUI.
1.
2.
Issue 02 (2020-09-07)
NO TE
The earlier version has Protocol setting on the screen. The actual screen prevails.
Log in to the ECC800-Pro WebUI as an administrator.
Add a NetCol5000-C030.
Table 8-21 Adding a NetCol5000-C030
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the NetCol5000-C030 connects to the
ECC800-Pro properly.
– If the NetCol5000-C030 connects to the ECC800-Pro successfully, click
Confirm. The connected devices are displayed in the Number of
connected devices list.
– If the connection fails, check whether the NetCol5000-C030 is properly
connected to the ECC800-Pro, whether the NetCol5000-C030 and
ECC800-Pro are running properly, and whether the parameter settings are
consistent with the NetCol5000-C030 parameters.
Log in to the ECC800-Pro WebUI as an administrator.
Choose Monitoring > Cooling > NetCol5000-C0301.
NO TE
1 in NetCol5000-C0301 is variable and subject to change with the smart cooling
product model and connection sequence. The displayed value prevails.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Air Conditioner from the drop-
down list box.
Select NetCol5000-C from the drop-down
list box.
Select ECC800 from the drop-down list
box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the
NetCol5000-C030 is connected to the COM1
port on the ECC800-Pro. If the NetCol5000-
C030 is connected to another port, enter the
number of the connected port.
In this example, Device Address is set to 1.
During actual configuration, set the device
address for the NetCol5000-C030 based on
the actual situation.
8 FAQ
292