How Can I Set And Add An Rpdu - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
3.
----End

8.1.7.15 How Can I Set and Add an rPDU?

Prerequisites
One end of the straight-through cable has been connected to the COM 1 or COM
2 port on the PDU2000, and the other end has been connected to the COM port
on the ECC800-Pro collector, UIM20A expansion module, or ETH converter.
Issue 02 (2020-09-07)
Table 8-13 Adding a 5G DC power supply
Path Parameter
Choose Device
System attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device. The
parameters
for adding
Communicati
devices are
ons Port
displayed.
Device
Address
Click Test Connect to check whether the 5G DC power supply is properly
connected to the ECC800-Pro.
– If the connection succeeds, click Confirm. The connected devices are
displayed in the Number of connected devices list.
– If the connection fails, check whether the 5G DC power supply is properly
connected to the ECC800-Pro, whether the 5G DC power supply and
ECC800-Pro are running properly, and whether the parameter settings are
consistent with the 5G DC power supply parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select a DC Power Source from the drop-
down list box.
Select MTS9604B_MTS9606B Power
Supply from the drop-down list box.
Select ETH Converter from the drop-down
list box.
Select COM1/COM2 from the drop-down
list box.
NOTE
The setting example indicates that the 5G DC
power supply is connected to the COM1 port on
the ECC800-Pro. If the 5G DC power supply is
connected to another port, enter the number of
the connected port.
In this example, Device Address is set to 1.
Set the device address based on the actual
situation.
8 FAQ
278