Engraving Cycle - Cycle60 - Siemens Sinumerik 840D sl Programming Manual

16.1.25

Engraving cycle - CYCLE60

Programming
CYCLE60(STRING[200] _TEXT, REAL _RTP, REAL _RFP, REAL _SDIS, REAL
_DP, REAL _DPR, REAL _PA, REAL _PO, REAL _STA, REAL _CP1, REAL _CP2,
REAL _WID, REAL _DF, REAL _FFD, REAL _FFP1, INT _VARI, INT _CODEP,
INT _UMODE, INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
Param Param
No.
Mask intern
1
_TEXT
2
RP _RTP
3
Z0 _RFP
4
SC _SDIS
5
Z1 _DP
6
Z1 _DPR
7
X0 _PA
R
8
Y0 _PO
α0
9 α1
_STA
10 XM
_CP1
LM
11 YM
_CP2
αM
12
W _WID
13
DX1 _DF
DX2
α2
14
FZ _FFD
15 F
_FFP1
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Explanation
Text to be engraved (up to 100 characters)
Retraction plane (abs)
Reference point of tool axis (abs)
Safety clearance (to be added to the reference plane, enter without sign)
Depth (abs), see _AMODE
Depth (inc), see _AMODE
Reference point in 1st axis of plane (abs) - right-angled, see _VARI
Reference point, length (radius) - polar, see _VARI
Reference point in 2nd axis of plane (abs) - right-angled, see _VARI
Reference point, angle with respect to 1st axis - polar, see _VARI
Text direction, angle of line of text with respect to 1st axis, see _VARI
Center of circle of text, 1st axis of plane (abs) - right-angled, see _VARI
Center of circle of text, length (radius) with respect to WNP - polar, see _VARI
: Center of circle of text, 2nd axis of plane (abs) - right-angled, see _VARI
Center of circle of text, angle with respect to 1st axis - polar, see _VARI
Height of characters (enter without sign)
Distance between characters / overall width, see _VARI
Opening angle, see _VARI
Depth infeed rate, see _DMODE
Feedrate for surface machining
Programming cycles externally
16.1 Technology cycles
787