Siemens Sinumerik 840D sl Programming Manual page 749

No. Param Mask Param intern
19
_DMODE
20
_AMODE
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Explanation
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the level effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
UNITS: Drilling depth = Final drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR programming
1 = Incremental
2 = Absolute
TENS: Dwell time at final drilling depth DTB in seconds/revolutions
0 = Compatibility from DTB sign (> 0 seconds or < 0 revolutions)
1 = in seconds
2 = in revolutions
HUNDREDS: Dwell time at start point of DTS in seconds/revolutions
0 = Compatibility from DTS sign (> 0 seconds or < 0 revolutions)
1 = in seconds
2 = in revolutions
THOUSANDS: Dwell time at final drilling depth DT in seconds/revolutions
0 = Compatibility from DTD sign (> 0 seconds or < 0 revolutions)
1 = in seconds
2 = in revolutions
TEN THOUSANDS: 1. Drilling depth D (abs/inc)
0 = Compatibility, from FDEP/FDPR programming
1 = Incremental
2 = Absolute
HUNDRED THOUSANDS: Amount/percentage DAM for each additional infeed
(degression)
0 = Compatibility, from DAM sign (> 0 seconds or < 0 factor 0.001 to 1.0)
1 = Amount
2 = Percentage (0.001 up to 100 %)
MILLION: Limit distance V3 automatic/manual
0 = Compatibility from _DIS1 sign (= 0 automatic or > 0 manual)
1 = automatic (calculated in the cycle)
2 = manual (programmed value)
TEN MILLION: Feed rate factor for first infeed FRF as factor/percentage
0 = Compatibility, as a factor (0.001 to 1.0, FRF = 0 means 100%)
1 = Percentage (0.001 up to 999.999 %)
Programming cycles externally
16.1 Technology cycles
749