Orientation Programming Along The Peripheral Surface Of A Taper (Oriplane, Oriconcw, Oriconccw, Oriconto, Oriconio) - Siemens Sinumerik 840D sl Programming Manual

Transformations
6.2 Three, four and five axis transformation (TRAORI)
6.2.8 Orientation programming along the peripheral surface of a taper (ORIPLANE,
ORICONCW, ORICONCCW, ORICONTO, ORICONIO)
Function
With extended orientation it is possible to execute a change in orientation along the peripheral
surface of a taper in space. The orientation vector is interpolated on the peripheral surface of
a taper using the ORICONxx modal command. The end orientation can be programmed with
ORIPLANE for interpolation on a plane. The start orientation is usually defined by the
previous blocks.
Figure 6-4
348
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning