5.5
Preset offset (PRESETON)
Function
For special applications, it may be necessary to assign an already referenced machine axis a
new actual value using PRESETON. This corresponds to a zero offset in the machine
coordinate system.
After PRESETON, the machine axis is in the "non-referenced" status. We therefore
recommend that the function is only used for machine axes that do not require a reference
point. In order to restore the original machine coordinate system, the machine axis must be
re-referenced, e.g. using G74 (reference point approach).
References: Programming Manual Basics, Supplementary Commands, Reference point
approach (G74)
Syntax
PRESETON(<axis>, <value>, ...)
Meaning
PRESETON
<axis>
<value>
Note
Setting actual values via synchronized actions should only be implemented with the keyword
WHEN or EVERY.
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
CAUTION
Preset actual value memory
Machine axis identifier
New actual value of the machine axis in the machine coordinate system
Coordinate transformation (FRAMES)
5.5 Preset offset (PRESETON)
307