Setup Part 4: Ip Configuration; Ip Interfaces - Lenovo RackSwitch G8264 Application Manual

Setup Part 4: IP Configuration

IP Interfaces

1. Select the IP interface to configure, or skip interface configuration at the prompt:
2. For the specified IP interface, enter the IP address in IPv4 dotted decimal notation:
3. At the prompt, enter the IPv4 subnet mask in dotted decimal notation:
© Copyright Lenovo 2016
The system prompts for IPv4 parameters.
Although the switch supports both IPv4 and IPv6 networks, the Setup utility
permits only IPv4 configuration. For IPv6 configuration, see Chapter 29, "Internet
Protocol Version 6."
IP interfaces are used for defining the networks to which the switch belongs.
Up to 126 IP interfaces can be configured on the RackSwitch G8264 (G8264). The IP
address assigned to each IP interface provides the switch with an IP presence on
your network. No two IP interfaces can be on the same IP network. The interfaces
can be used for connecting to the switch for remote configuration, and for routing
between subnets and VLANs (if used).
Note: IP interface 128 is reserved for out‐of‐band switch management.
IP Config:
IP interfaces:
Enter interface number: (1­126)
If you wish to configure individual IP interfaces, enter the number of the IP
interface you wish to configure. To skip IP interface configuration, press <Enter>
without typing an interface number and go to "Default Gateways" on page
Current IP address: 0.0.0.0
Enter new IP address:
To keep the current setting, press <Enter>.
Current subnet mask: 0.0.0.0
Enter new subnet mask:
To keep the current setting, press <Enter>.If configuring VLANs, specify a VLAN
for the interface.
The following prompt appears if you selected to configure VLANs back in Part 1:
Current VLAN: 1
Enter new VLAN [1­4094]:
Enter the number for the VLAN to which the interface belongs, or press <Enter>
without specifying a VLAN number to accept the current setting.
77.
75
Chapter 2: Initial Setup