Example 2: PIM-SM with Static RP
Example 3: PIM-DM
594
G8264 Application Guide for ENOS 8.4
The following commands can be used to modify the prior example configuration to
use a static RP:
RS G8264(config)# ip pim staticrp enable
RS G8264(config)# ip pim component 1
RS G8264(configippimcomp)# rpstatic rpaddress 225.1.0.0 255.255.0.0
10.10.1.1
RS G8264(configippimcomp)# exit
Where 225.1.0.0 255.255.0.0 is the multicast group base address and mask, and
10.10.1.1 is the static RP address.
Note: The same static RP address must be configured for all switches in the group.
This example configures PIM Dense Mode (PIM‐DM) on one IP interface. PIM‐DM
can be configured independently, or it can be combined with the prior PIM‐SM
examples (which are configured on a different PIM component) as shown in
Figure
56.
Figure 56. Network with both PIM‐DM and PIM‐SM Components
PIM-SM
Multicast
225.1.0.0/16
PIM Enabled
Switch
IP Interface 11
IP 10.10.1.1
VLAN 101
Component 1
Media
Servers
PIM-DM
Multicast
239.1.0.0/16
IP Interface 22
IP 10.10.2.1
VLAN 102
Component 2