Configuration Guidelines
Configuration Example
1. Select a VLAN and define the Private VLAN type as primary.
2. Configure a promiscuous port for VLAN 700.
3. Configure two secondary VLANs: isolated VLAN and community VLAN.
4. Map secondary VLANs to primary VLAN.
170
G8264 Application Guide for ENOS 8.4
The following guidelines apply when configuring Private VLANs:
Management VLANs cannot be Private VLANs. Management ports cannot be
members of a Private VLAN.
The default VLAN 1 cannot be a Private VLAN.
IGMP Snooping must be disabled on Private VLANs.
All VLANs that comprise the Private VLAN must belong to the same Spanning
Tree Group.
A VLAN pair consists of a primary VLAN and one associated secondary VLAN
(isolated or community). The maximum number of VLAN pairs per port is 16.
Follow this procedure to configure a Private VLAN.
RS G8264(config)# vlan 700
RS G8264(configvlan)# privatevlan primary
RS G8264(configvlan)# exit
RS G8264(config)# interface port 1
RS G8264(configif)# switchport mode privatevlan
RS G8264(configif)# switchport privatevlan mapping 700
RS G8264(configif)# exit
RS G8264(config)# vlan 701
RS G8264(configvlan)# privatevlan isolated
RS G8264(configvlan)# exit
RS G8264(config)# vlan 702
RS G8264(configvlan)# privatevlan community
RS G8264(configvlan)# exit
RS G8264(config)# vlan 700702
RS G8264(configvlan)# stg 1
RS G8264(configvlan)# exit
RS G8264(config)# vlan 700
RS G8264(configvlan)# privatevlan association 701,702
RS G8264(configvlan)# exit