Basic System Mode Configuration Example
Transparent Mode Configuration Example
© Copyright Lenovo 2016
This example shows the parameters available for configuration in Basic System
mode:
RS G8264# easyconnect
Configure Basic system (yes/no)? y
Please enter "none" for no hostname.
Enter hostname(Default: None)? host
Please enter "dhcp" for dhcp IP.
Select management IP address (Current: 10.241.13.32)?
Enter management netmask(Current: 255.255.255.128)?
Enter management gateway:(Current: 10.241.13.1)?
Pending switch port configuration:
Hostname: host
Management interface:
IP: 10.241.13.32
Netmask: 255.255.255.128
Gateway: 10.241.13.1
Confirm erasing current config to reconfigure Easy Connect (yes/no)?
Note: You can either accept the default values or enter new parameters.
This example shows the parameters available for configuration in Transparent
mode:
RS G8264# #easyconnect
Configure Transparent mode (yes/no)? y
Select Uplink Ports (Static Defaults: 1724)?
The following Uplink ports will be enabled:
Uplink ports(1G/10G): 1724
Select Server Ports (Static Defaults: 2564)?
The following Server ports will be enabled:
Server ports(1G/10G): 2564
Pending switch configuration:
Uplink Ports: 1724
Server Ports: 2564
Disabled Ports: 1,5,9,13
Confirm erasing current config to reconfigure Easy Connect (yes/no)?
Notes:
If your selection for a port group contains ports of different mode or speed, the
selection is not valid and you are guided to either select other ports or change
the speed of the ports.
You can either accept the static defaults or enter a different port list for uplink
and/or server ports.
Chapter 1: Switch Administration
49