Using UFP with Other RackSwitch G8264 Features
Layer 2 Failover
Increased VLAN Limits
Private VLANs
© Copyright Lenovo 2016
UFP works with other G8264 features, as described with limitations and details.
UFP failover can be configured with auto‐monitoring or manual monitoring. In
auto‐monitoring, a vPort is automatically associated with a Failover trigger if it has
any VLAN in common with the monitor ports.
For more information on failover, see Chapter
For an example configuration, see "Example 6: Layer 2 Failover Configuration" on
page
426.
Configured with UFP and VLANs, a vPort can support maximum 1024 VLANs. A
UFP port supports 1024 VLANs.
For more information on VLAN configuration, see Chapter
It supports the following Private VLAN modes in UFP vPorts:
Disabled
Trunk
Promiscuous
Host
The following are the criteria of these Private VLAN modes:
Private‐VLAN mode is disabled:
Allows only non‐private domain.
Private‐VLAN mode is trunk:
Allows both primary and secondary VLAN which belong to the private
VLAN domain.
Allows non‐private VLAN domains.
vPorts belonging to the same UFP port cannot be in the same private‐VLAN
domain.
For the traffic of a specific VLAN to be passed through a port, requires the
port to be explicitly added to that VLAN. For example, for a UFP port to pass
traffic in private VLAN primary 100 and secondary 10, the port must be
added to both VLAN 100 and VLAN 10.
Since this port type is intended to be functional as an ISL port, the
isolate‐VLAN is allowed to pass traffic through this port type.
38, "Layer 2 Failover."
9, "VLANs."
Chapter 25: Unified Fabric Port
419